Hello

I am looking for changing the nipples of the lower end of kingpins for a better access by 45° angle type.
Do you know size and thread type of those parts
I am a little lost in the BSP, UNF and want to avoid to purchase a kit of 110 pcs to find 2 units that match...
Thanks in advance for your help

Had a similar problem with my plus 4 and got round it by putting a washer under the grease nipple, the nipple was then pointing the right way for the grease gun.

Lower ones are 1/4 BSF and you will need washers to set the alignment. I used one washer on the off side and two on the near side.

Thanks a lot Paul
will take care of washers
Cheers