Originally Posted By timpot7
Thanks a lot fellers for all your suggestions and good advice. I got the front end of the car up on a steep driveway which gave me crawl space under the area that I need to have a look at. There was nothing untoward to be seen. So I am none the wiser however I am happier now that I can see that there is no major damage. I will contact the Morgan dealer in Lisbon and see if they can have a look at it.
Thanks Again
Tim

Hello Tim,

When I holed my sump the Gearbox Engine Mounting ( located on top of the Cross Member Hump) Sheared Off very easily and the two Front Mountings distorted preventing a new Gear Box Mounting being fitted. I had to have all three replaced.

The front edge of the Bell Housing is probably what you hit? It is just a few mm lower than the Cross Member.

It sounds as though yours has sheared. But it is difficult to see it without putting the car up on a ramp and trying to lift the bell housing. It is very lucky that the Sump did not go.

The rear end of the Engine also holed the Brake Master Cylinder so also check there for any damage. Mine also needed to be replaced.

I hope this helps
Frank


http://franks4x4-solograndetour.blogspot.co.uk/
Combat Stress-http://www.justgiving.com/Roadster100