Talk Morgan Forums Community The Malvern Arms High level brake light.

The existing light will have connectors into the harness, if your lucky they will be bullet connectors as used all over the car. If so most likely singles, pop to Halfords or a car accessory shop and get 2 double bullet connector blocks (2 metal tubes covered in an outer rubber insulating sheath, and some of the metal bullets for your lamp. If you find a different connector then you need the same pair of double connectors but 6 bullets, cut off the OE connectors (only if ithey are none bullet type) and you will have 4 wires, put a bullet on each and also on your new lamp. Finally connect all thre Earth ends into one double connector and the three feed wires into the other, (you will have one spare end at each double connector of course) push the bullets well in with a small screwdriver if you don't have the correct Ripaults pliers or pop over to Leicester for a day out and I will do it for you, coffee available as well ;-). Have a go and shout if you get stuck.