Post Photobucket reboot from April 2011 continued.........

The lifting bar is made up Pete, and is the third version. The first one was a short (say 10") piece of floorboarding with wooden edges to stop slippage. Then I moved to a more streamlined version which fitted between the over-rider brackets with a rough cut U section metal channel.
Then when I fitted my undertray I needed something a bit better, so the full width bar is made to spread the load a bit more. There's a simpler version for the rear.
Even with the alloy L sections though, the timber does bend a bit. The red & white electrical tape is for centrering.
At the rear I've used a couple of trim nipples, male lift the dots, in the floorboards to locate the bar.



This is the front bar in progress...........







thumbs




DaveW
'05 Red Roadster S1
'16 Yellow (Not the only) Narrow AR GDI Plus 4