I did some wrap work on my Boardtrack racer bike build. I had them ceramic coated first, but had three spots that I wanted to add protection from the heat.
I used this:
SunPlus Trade 2" wide exhaust wrapI had never done this before, but was concerned when they said that it would not be covered if I did NOT use a black silicone spray on the exhaust wrap after it was dry. This was not an easy task for me as I had to take the exhaust pipes off to wrap and then reinstall to dry and shrink them out. Once dry I took them all back off and sprayed several coats of the black silicone spray on the wrap. Also not easy was I wanted the stainless steel wrap ties to show after the silicone spray was done. I masked off each SS tie and then sprayed the wrap sections. Once dry and back on, they look great and there's no fuzzy edges either as the black silicone spray coated and hardened them.
Can't tell you how much longer it will last than normal, but this wrap looks good and had many good reviews.
I also purchased a bag of:
Stainless Steel wrap ties These were only $13.99 for 100 ties. I used small needle nose pliers to twist up the ends and tighten them up. Worked okay, but a tensioner tool would have been better.
For whatever reason at the moment it won't let me upload a 375 b size picture, should work.
Good luck with you exhaust wrap.
Have a great week!
Dan
