Originally Posted by Guten
Originally Posted by bmgermany
Perhaps I have overlooked the answer to my question here, in which case I apologise.


Is the seat foam of the 2005 reclining seats glued to the cover?

If so, it is certainly more difficult to fit carbon heftig pads?
Also because the cover is quilted lengthwise.



Got one seat done today, also fitted new webbing base (my bum was getting a bit numb on long journeys). I see the kit comes with a relay for each seat as you say TBM. As far as glue is concerned, the base was stuck to the foam but not the back. Also there is a “flap” of leather cloth sewn in to the seam between the base cushion and the bolster under the thighs which was anchored to the frame. I cut this down in width a little, made a cut in the base heater and fed it through. It all seemed to go back together ok. Will do the passenger seat, re-fit and then sort the wiring run and switch location.


Thank you Simon,

I´ll have to look closer to my seats to find out if this is a way with my seats.

Perhaps someone has some pictures from the individual parts of the recliner seats confused2


2005 4/4 1800ccm Duratec and a lot of HONDA CX500.......