|
|
|
|
|
|
|
|
Wales
by Joske Vermeule, September 1
|
|
|
Forums39
Topics49,914
Posts838,171
Members9,635
| |
Most Online1,063
Jun 14th, 2026
|
|
|
|
Joined: Mar 2013
Posts: 722 Likes: 24
Talk Morgan Regular
|
Talk Morgan Regular
Joined: Mar 2013
Posts: 722 Likes: 24 |
@ OZ 4/4
we are all adults and make our own decisions. having a morgan!
so either you start writing helpful and constructive solutions, or "just shut up"! this forum is about joie de vivre and positive attitude.
your constant negative comments are neither helpful nor constructive. on the contrary!!! Completely agree with that !!!
|
|
|
|
|
Joined: Jun 2015
Posts: 580 Likes: 2
Talk Morgan Regular
|
|
Talk Morgan Regular
Joined: Jun 2015
Posts: 580 Likes: 2 |
I see from the photograph, which shows details of the pedals much better than by eyeball, that the whole braking torque is not taken by the tube (and weld(s) between the pedal and the m/c actuation lever. If you look at the photo, you will see that the clevis pin through the actuation lever and m/c fork, also extends into the brake pedal, thus sharing the braking load with the torque tube. Wilson https://www.tm-img.com/image/cXQ6c Wilson from your photo we can see the clutch pedal does have the clevis pin going through actuation lever & pedal. On the brake pedal the clevis pin looks to only go through the actuation lever. There is a split pin on the left of the clevis. Thus the whole brake load goes through the actuation lever & torque tube Tim Hi Tim, You are absolutely correct that the clevis pin does not carry on through the brake lever. I checked by putting a small mirror behind the brake pedal and reflected a torch onto it. My photo was a bit deceptive, as in that the end of the clevis pin was sitting hard against the RH edge of the pedal. Very strange design decision, when it would have been so easy to drill the brake pedal and use a longer clevis pin. This would have reduced the cantilever forces from the current arrangement. I am guess that the mod may be a dog leg bracket going from the RHS of the actuator lever and fixing to the brake pedal above the clevis pin. Wilson
|
|
|
|
|
Joined: May 2015
Posts: 1,815 Likes: 32
Talk Morgan Enthusiast
|
|
OP
Talk Morgan Enthusiast
Joined: May 2015
Posts: 1,815 Likes: 32 |
...Normally I would have chased them up during the past week but spent the whole week sorting out the consequences of a burglary at my French house on Monday night, where I was either gassed or drugged (ketamine spray) and was quite ill afterwards for a couple of days.
Wilson Wow - wishing you a safe recovery (and justice!)...
M3W5sp 2015, MSCC, MTWC, Oxon UK
|
|
|
|
|
Joined: Dec 2009
Posts: 37,490 Likes: 994
Tricky Dicky Member of the Inner Circle
|
|
Tricky Dicky Member of the Inner Circle
Joined: Dec 2009
Posts: 37,490 Likes: 994 |
+1 Sorry to read this Wilson that's shocking.
2009 4/4 Sport Henrietta
1999 Indigo Blue +8
2009 4/4 Sport Green prev
1993 Con Green +8 prev
|
|
|
|
|
Joined: Jun 2015
Posts: 580 Likes: 2
Talk Morgan Regular
|
|
Talk Morgan Regular
Joined: Jun 2015
Posts: 580 Likes: 2 |
Wow - wishing you a safe recovery (and justice!)...
Feeling OK now and I got off lightly. They burgled two other houses in the village and beat up an old lady to get the combination of her safe. According to the police it is a professional gang. I found rubber gloves dumped outside the house the next day. I suspect I woke up too quickly for them, as I have worn opioid patches for the last 15 years for my degenerative scoliosis and may therefore be more drug resistant than most. I woke up and needed to be ill instantly and as I went into the bathroom, I saw the outside security light flick on, which was them legging it. They could have taken a lot more, so I must be thankful for that. Bolting the stable door after the horse has bolted, I am now having more bars put on the windows and upgrading my alarm system. Thanks for the good wishes. Wilson
|
|
|
|
|
Joined: Jul 2013
Posts: 3,735 Likes: 80
Talk Morgan Addict
|
|
Talk Morgan Addict
Joined: Jul 2013
Posts: 3,735 Likes: 80 |
+1 glad you're relatively OK WIlson and I hope the old lady makes swift recovery.
Good luck to the gendarmes to get the scum who attacked you.
Last edited by Chris99; 29/06/19 04:58 PM. Reason: Typo
Red Leader 
|
|
|
|
|
Joined: Aug 2012
Posts: 2,360 Likes: 2
Talk Morgan Expert
|
|
Talk Morgan Expert
Joined: Aug 2012
Posts: 2,360 Likes: 2 |
Bad News wilson
Have a good rest
And find Time to ride in Mtw
|
|
|
|
|
Joined: Feb 2019
Posts: 3,857 Likes: 2
Talk Morgan Addict
|
|
Talk Morgan Addict
Joined: Feb 2019
Posts: 3,857 Likes: 2 |
Wilson, you are very fortunate to have survived since such incidents can cause heart attacks. We got a very noisy German Shepherd that woofs at anything strange and that would awaken myself which would put me into combat mode and armed accordingly. If I survived there would be a lot of paperwork to file out once the coroner and the police left!
I hope they catch those pukes and do more than slap them on the wrist saying they must have had a bad childhood.
Get well so you can enjoy the M3W.
2019 M3W Sold and is now in Las Vegas enjoying the showgirls :-)
|
|
|
|
|
Joined: Mar 2011
Posts: 400 Likes: 15
Learner Plates Off!
|
|
Learner Plates Off!
Joined: Mar 2011
Posts: 400 Likes: 15 |
Thanks to good work by our dealer (RTCC) getting the bits, we have today had the extra bracket/pins added to the brake pedal to fix the concern raised in the MMC message. A neat enough job that overcomes the strangeness of the original design pointed out by Wilson.
|
|
|
|
|
Joined: Mar 2014
Posts: 1,740 Likes: 57
Talk Morgan Enthusiast
|
|
Talk Morgan Enthusiast
Joined: Mar 2014
Posts: 1,740 Likes: 57 |
Thanks to good work by our dealer (RTCC) getting the bits, we have today had the extra bracket/pins added to the brake pedal to fix the concern raised in the MMC message. A neat enough job that overcomes the strangeness of the original design pointed out by Wilson. Any chance of a photo?  Preferably posted in this THREAD 
Last edited by Bunny; 02/07/19 07:42 PM.
Andy
|
|
|
|
|
