Combining PeterG's rubber strip and HJP'S cut down plexiglass , fit a rubber strip cut from sheet rubber the thickness of the plexi in place of the plexi in the body slots, held in by the bolts in the same way as the plexi, sticking up just enough to touch the lower side of the aero screens ?
The shape would approximate to atlante's aluminium filler piece, but be about an inch taller.
This would achieve the effect seen in the photo above where there is a black band below the windscreen.
Good idea
If you can get the rubber in a thickness to fill the strip left by the removal of the plexi glass and silicon, it would make replacement in the future of the worn rubber very economical and a reasonably easy job.
Now if we can get the strip in the middle filled in as well raise the height of the windscreen frames we can start on the roof
