Hello everyone!
Back to this subject. MMC replied to my dealer here in Madrid about my "classic" oil seal leak at the front of the bevel box. Here's their reply:
"You will have to cut through the steel bracket over the propshaft to enable you to remove the propshaft. (After the repair, you must weld the bracket back together.) You will have to replace the nose cone oil seal. Make a mark on the nut, flange and bevel box pinion. Undo the nut and remember to count the number of turns out. Replace the seal. Fit the flange in the same position. Refit the nut and remember to count the number of turns back on. They must be the same. (Please note that the front pinion nut has a backwards thread!)."
I've seen the videos from Phil Bleazey about how to replace it and all the possible documents. But I want to be 100% sure that I order the proper Viton best O-ring instead of letting them put acheap standard one back.
Can you please confirm to me where through internet exactly and which reference is the good one to buy?
Thanks!!!
Last edited by Marmota; 04/02/21 12:30 PM.
