I have a 15t upside down bottle jack one. I rarely use it near to it's limit but this does depend on what you plan to use it for. I used to do a lot of two stroke cranks and some would need a lot of force to part them. Honda ones in particular I had a problem with. But for normal bending stuff for brackets, pushing bushes in and out (mog king pins), bending sheet metal etc then 10t is OK. So 20t is ample. A two speed function would be useful at times, also lifting the carriage between settings can be an effort, when set up for a job and you run out of travel in the ram. A winch for this would be useful.
Apart from that have fun and any press is better than the one you have not got.
Cheers
John.
PS too much force and you can do a lot of damage!!! Don't ask how I know. LoL.
Last edited by John07; 06/05/24 12:49 PM.
