Originally Posted By cerealsurfer
2nd the Rev...probably the only one that will fit anyhow.

I'd recommend the Ali Sparco Pro mouns that go under the seat. You can do a trim job to get them round the rear chassis cross rail. They're the best quality fit and provide the lowest seating position.

Not strictly true- Mulfab do correctly fitting side mounting Morgan ones that fit the seat as low as possible
http://www.mulfab.co.uk/our-products/7/other-miscellaneous

If you are feeling really adventurous it is also possible to modify the crossmember behind the seats to gain legroom and lose another inch or so of seat height

http://www.demon-tweeks.co.uk/performanc...eat-mounts-pair

You'll also need to trim the seat edge round the transmission tunnel - just pull back the cover and trim with saw. If you are fitting 2 you'll need to trim the wing section where your shoulders go as the two seats foul each other when fitted.

you should be made aware that modifying the seat in anyway invalidates any manufacturers liability or warranty

Simon @ Sifab.co.uk

Sifabtemporary@gmail.com