|
2 members (DaveW, flyfisher),
109
guests, and
17
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
Old Book
by Morganmike - 21/09/26 07:54 PM
|
|
|
|
|
|
|
Goodwood
by waikiore - 19/09/26 02:50 PM
|
|
|
|
|
|
|
Forums39
Topics49,932
Posts838,511
Members9,638
| |
Most Online1,063 Jun 14th, 2026
|
|
|
|
Joined: Dec 2008
Posts: 22,385 Likes: 358
Roadster Guru Member of the Inner Circle
|
OP
Roadster Guru Member of the Inner Circle
Joined: Dec 2008
Posts: 22,385 Likes: 358 |
Bear in mind that when the Roadster Sport was introduced, (09), the front cross tubes were made a bit wider on the Roadster.
So - 2005 Roadster - distance between kingpin centres at the bottom - 1030mm; 2012 4/4 - 1030mm (40.5"). The same width.
Rear axle, spinner to spinner measured externally using my tracking tool: 2005 Roadster 1693mm. 2012 4/4 - 1693mm. The same. This confirms my theory that the difference in width is down to wheel offset. Rear wing width measured from the top, from side of body to edge of wing - Roadster 20cm. 4/4 16.3cm (each side).
And the 2 litre zetec sump is not the lowest point. it's tucked up well away from harm. The low point apart from the gearbox crossmember is the bellhousing but there's over 4.25" clearance which is an inch more than the Roadster sump.
DaveW '05 Red Roadster S1 '16 Yellow (Not the only) Narrow AR GDI Plus 4
|
|
|
|
|
Joined: Mar 2009
Posts: 3,832 Likes: 69
Talk Morgan Addict
|
Talk Morgan Addict
Joined: Mar 2009
Posts: 3,832 Likes: 69 |
OK, ok , so you've got TWO Mogs to measure......stop bragging! It obviously went well today Dave. Congrats. Nick
|
|
|
|
|
Joined: Dec 2008
Posts: 22,385 Likes: 358
Roadster Guru Member of the Inner Circle
|
OP
Roadster Guru Member of the Inner Circle
Joined: Dec 2008
Posts: 22,385 Likes: 358 |
Well, tired after the trip, but not too tired to get the tape out.
Plus my hawkeye neighbour who sussed me out within five minutes of getting back...............
"Collecting them are we?" he said
DaveW '05 Red Roadster S1 '16 Yellow (Not the only) Narrow AR GDI Plus 4
|
|
|
|
|
Joined: May 2011
Posts: 4,896
Drive on the Wild Side Part of the Furniture
|
Drive on the Wild Side Part of the Furniture
Joined: May 2011
Posts: 4,896 |
It's not the the width that's important
Adrian
Buggered Off, to a modern none leaky car, heart's still ticking
|
|
|
|
|
Joined: Dec 2008
Posts: 22,385 Likes: 358
Roadster Guru Member of the Inner Circle
|
OP
Roadster Guru Member of the Inner Circle
Joined: Dec 2008
Posts: 22,385 Likes: 358 |
Is it the rhythm? Because that's going to get you. 
DaveW '05 Red Roadster S1 '16 Yellow (Not the only) Narrow AR GDI Plus 4
|
|
|
|
|
Joined: May 2011
Posts: 4,896
Drive on the Wild Side Part of the Furniture
|
Drive on the Wild Side Part of the Furniture
Joined: May 2011
Posts: 4,896 |
Adrian
Buggered Off, to a modern none leaky car, heart's still ticking
|
|
|
|
|
Joined: Oct 2007
Posts: 1,502
Talk Morgan Enthusiast
|
Talk Morgan Enthusiast
Joined: Oct 2007
Posts: 1,502 |
I thought you needed a narrower car - presumably it did fit...? Looks like you've only saved 7cm?
|
|
|
|
|
Joined: Dec 2008
Posts: 22,385 Likes: 358
Roadster Guru Member of the Inner Circle
|
OP
Roadster Guru Member of the Inner Circle
Joined: Dec 2008
Posts: 22,385 Likes: 358 |
The most crucial 7cm in the world................... And yes it does fit - just.
DaveW '05 Red Roadster S1 '16 Yellow (Not the only) Narrow AR GDI Plus 4
|
|
|
|
|
Joined: Jul 2011
Posts: 1,948
Talk Morgan Enthusiast
|
Talk Morgan Enthusiast
Joined: Jul 2011
Posts: 1,948 |
Rear wing width measured from the top, from side of body to edge of wing - Roadster 20cm. 4/4 16.3cm (each side) Congratulations. Not just on the new car, but on finding two symmetrical Morgans! What are the chances...?
Stuart "There's no skill substitute like cubic inches."
|
|
|
|
|
Joined: Jul 2007
Posts: 28,916 Likes: 354
Salty Sea Dog Member of the Inner Circle
|
Salty Sea Dog Member of the Inner Circle
Joined: Jul 2007
Posts: 28,916 Likes: 354 |
Graham (G4FUJ)
Sold L44FOR 4/4 Giallo Fly '11 MINI Countryman Cooper D All4 '90 LR 90 SW
|
|
|
|
|