|
|
|
|
|
|
|
|
|
|
|
|
Sold
by simon8201 - 09/09/26 01:46 PM
|
|
|
|
|
|
|
|
Wales
by Joske Vermeule, September 1
|
|
|
|
|
Forums39
Topics49,899
Posts838,030
Members9,635
| |
Most Online1,063 Jun 14th, 2026
|
|
|
There are no members with birthdays on this day. |
|
|
|
Joined: Feb 2009
Posts: 7
New to Talk Morgan
|
OP
New to Talk Morgan
Joined: Feb 2009
Posts: 7 |
Hi - I'm having an intermittent problem with the speedo on my 2002 +8 - with 15k on the clock. It'll be reading normal, and then the needle will just "drop" back to zero for a few seconds, then whip back up again to the correct speed. Then, it can be a bit "sluggish" and seem to be slow in getting up to speed. Also, the mileage LCD will sometimes go blank. Any ideas of the causes? Has anyone else had this? What's the solution?  Cheers all.
|
|
|
|
|
Joined: Mar 2007
Posts: 2,321
Talk Morgan Expert
|
Talk Morgan Expert
Joined: Mar 2007
Posts: 2,321 |
Welcome  If your speedo is electronic, I suspect the most likely cause would be bad earth....
|
|
|
|
|
Joined: Aug 2006
Posts: 7,934 Likes: 133
Talk Morgan Guru
|
Talk Morgan Guru
Joined: Aug 2006
Posts: 7,934 Likes: 133 |
This may be of assistance.
|
|
|
|
|
Joined: Feb 2009
Posts: 7
New to Talk Morgan
|
OP
New to Talk Morgan
Joined: Feb 2009
Posts: 7 |
Good stuff on that link - thanks Simon. At this stage dunno if it's mechanical or electrical. Let's assume (because the speedo has electronic odometer) that I've a "later" version of the cable, in 3 parts. And that because I'm _not_ getting a heap of MIL lights and/or poor performance, that the link up to the transducer is OK. So that would suggest it's in the final stage from transducer to speedo. But then, as the speedo page says "the cable will inevitably (5 minutes - 20 years) ..." which sums up Mogs  So it could be electronic/bad earth. Soo - time to have a root around I guess...
|
|
|
|
|
Joined: Mar 2007
Posts: 2,321
Talk Morgan Expert
|
Talk Morgan Expert
Joined: Mar 2007
Posts: 2,321 |
Whenever I have some electronic issues, its almost always has something to do with earth!!! Not that I had many, just twice, one for temp gauge swinging wildly from cold to hot, second time was indicators stop flashing with the horn beeping non-stop..both times were a simple earthing fault 
|
|
|
|
|
Joined: Feb 2009
Posts: 25
Just Getting Started
|
Just Getting Started
Joined: Feb 2009
Posts: 25 |
Hi New to the site and saw your problem. I have a 99 +8 and had allsorts of problems with VDO speedo. I could do 140mph sitting at traffic lights !! Worse bit was seemingly doing 80 in a 30 MPH area. Took it to Morgan who many £££ later still did not know what the problem was.Took head to VDO in Birmingham who tested it, no joy. Took the lead from the alternator off as it was possibly pulsating, no joy. Long story short it was a £1.89 capacitor that was at fault. It is behind the speedo and only the size of a matchhead in a shrouding between two sets of cables. No problems since. I have also lost the read out on occasions on the digital mileage display. Put it on a radiator overnight and it all came back. Best of luck.
|
|
|
|
|
Joined: Feb 2009
Posts: 7
New to Talk Morgan
|
OP
New to Talk Morgan
Joined: Feb 2009
Posts: 7 |
Worse bit was seemingly doing 80 in a 30 MPH area. Nah - having the speeds the other way around when you go past a camera, surely  Long story short it was a £1.89 capacitor that was at fault. It is behind the speedo and only the size of a matchhead in a shrouding between two sets of cables. No problems since. I have also lost the read out on occasions on the digital mileage display. Put it on a radiator overnight and it all came back. Is getting the entire speedo assembly out needed to get at this capacitor? And if so, is that tricky? And could be a damp issue with the mileage - I do get condensation when it hasn't been used for a bit. And it def hasn't been used for a bit over the winter 
|
|
|
|
|
Joined: Feb 2009
Posts: 25
Just Getting Started
|
Just Getting Started
Joined: Feb 2009
Posts: 25 |
Hi, Yes you do have to take the speedo out. It is held on by a large plastic O ring. It is quite simple but the capacitor has to be sweated in so it is best to take the speedo out to give more room for the process. Yes you are right, the read out is susceptible to damp conditions. Mine sits outside under a cover at the moment til I get round to building a garage. Looks pretty sad at the moment but still using it in the snow. Can you help please, how do I get the icons to go in the text box? I click the circle but click and drag does not work.
|
|
|
|
|
Joined: Aug 2006
Posts: 2,094 Likes: 260
The TM in Talk Morgan Talk Morgan Expert
|
The TM in Talk Morgan Talk Morgan Expert
Joined: Aug 2006
Posts: 2,094 Likes: 260 |
Can you help please, how do I get the icons to go in the text box? I click the circle but click and drag does not work. Do you mean the Smilies?  If so, click on he Yellow smilie face to open the pop-up window and press the smilie you want. It will insert it where your cursor is in the text.  I hope that helps.
|
|
|
|
|
Joined: Feb 2009
Posts: 25
Just Getting Started
|
Just Getting Started
Joined: Feb 2009
Posts: 25 |
Think I am getting there evntually  So thank you for your help. Here's another just to get the hang of it 
|
|
|
|
|