Well done Richard, your not a 3W virgin anymore!!!life will never be the same again. Ref the left leg. If you can raise your knee a little and poke your toe between clutch and brake pedel. I am 5'11" with 32 inside leg. Works for me just fine.
5'10" 32" inseam as well. Drive a few more miles. You'll get adjusted.
Happy days with the car Richard. I'm 33" leg. I can get by OK, but Hugh fitted a larger Moto Lita wheel, so it clears the left knee. Just pivot L ankle to the left and don't wear Doc Martins.
Well done Richard, your not a 3W virgin anymore!!!life will never be the same again. Ref the left leg. If you can raise your knee a little and poke your toe between clutch and brake pedel. I am 5'11" with 32 inside leg. Works for me just fine.
Thanks will try that. I'm 5'10" with 31" leg so similar. Did consider the need to move pedal box forward but was wearing flying jacket at the time. I'm hoping moving the wheel an inch closer to me will allow a little more leg movement.
Richard
2018 Roadster 3.7 1966 Land Rover S2a 88 2024 Royal Enfield Guerrilla 450 1945 Guzzi Airone
The weather forecast looks good and it would be a great way to get through the inintal running in.
Thanks for welcome to M3W ownership from yourself and others. Sadly too many commitments to make the blat, having to my time between partner, narrowboat and motorcycle. Look forward to a far more practical form of personal transport though. My journey to collect car took six legs on Saturday morning
Short video - excuse commentary from my ebullient brother! Carrier to be black powder coated.
Last edited by Richard Wood; 02/05/1606:25 PM.
Richard
2018 Roadster 3.7 1966 Land Rover S2a 88 2024 Royal Enfield Guerrilla 450 1945 Guzzi Airone
The Moto Lita steering wheel looked a bit plain and the dash area of Thumper is a bit anonymous.
So I have attached some Morgan wings to the centre of the steering wheel. These are a 50mm badge from the MMC web shop. The clasp was removed but two rivets were left behind to give retention for the 24hr epoxy adhesive. The fit surface off the badge was also roughened up, along with the centre of the steering wheel. Two depressions were cut in to the aluminium with a rose head bur to locate the wings.