Click here to return to the home page.
Classic Morgans
Who's Online Now
7 members (Heinz, Barry M, +8Rich, hillclimber, JohnHarris, RedThree, MJF), 221 guests, and 83 robots.
Key: Admin, Global Mod, Mod
Top Posters(30 Days)
+8Rich 86
Newest Members
Scot_SJI, Jimmers, Breen60, Davidmog, Stevecarr
9,596 Registered Users
Newest Topics
UK Government vehicle regs changes afoot..?
by Luddite - 30/08/26 09:02 AM
Wheel balance in South Devon
by AndyGoff - 29/08/26 06:24 PM
JayEmm Supersport test vid.
by Luddite - 29/08/26 11:32 AM
Grille Question
by SteveT - 29/08/26 10:51 AM
Back to Morgan!
by SteveT - 28/08/26 07:12 PM
One for howard
by +8Rich - 28/08/26 10:05 AM
Renewing the twin aero horns
by Moggo - 27/08/26 05:24 PM
Latest Photos
tow bar
tow bar
by G Walker, August 24
Prescott double anniversary
Prescott double anniversary
by CooperMan, August 18
Air Crash Sites: Cairngorms
Air Crash Sites: Cairngorms
by RedThree, August 13
Four-seater luggage rack
Four-seater luggage rack
by Soleng, August 9
New M3W orange 2012
New M3W orange 2012
by jejemek, August 7
Forum Statistics
Forums39
Topics49,848
Posts837,403
Members9,596
Most Online1,063
Jun 14th, 2026
Today's Birthdays
DazMog, The Impaler, tlchzj79
Previous Thread
Next Thread
Print Thread
Page 1 of 3 1 2 3
#555949 25/01/19 10:33 PM
Joined: May 2016
Posts: 51
E
Just Getting Started
OP Offline
Just Getting Started
E
Joined: May 2016
Posts: 51
Maybe going over my limit today on posting. 2018 Roadster have been through the State Police inspection, registering and getting temporary plates. Went this morning to have a Maryland State Safety inspection done. They were up able to inspect the car because it is not in their data base or did they have any specs to compare to. I need the following: it can just be from an existing car or the factory, but must be correct.
Need brake or drum new specs and discard specs. The ball joint or kingpin depending on what is on the car, need horizontal and vertical play.
Thanks

Joined: Dec 2009
Posts: 37,408
Likes: 977
Tricky Dicky
Member of the Inner Circle
Online Content
Tricky Dicky
Member of the Inner Circle
Joined: Dec 2009
Posts: 37,408
Likes: 977
Good luck with this - can Bill or Denis help out with this ?

Failing that there are TM members that work at the factory and maybe will jump in and help you overcome this administrative task.


2009 4/4 Sport Henrietta
1999 Indigo Blue +8
2009 4/4 Sport Green prev
1993 Con Green +8 prev





Joined: Feb 2016
Posts: 8,667
Likes: 408
Needs to Get Out More!
Offline
Needs to Get Out More!
Joined: Feb 2016
Posts: 8,667
Likes: 408
PM sent.


Richard

2018 Roadster 3.7
1966 Land Rover S2a 88
2024 Royal Enfield Guerrilla 450
1945 Guzzi Airone
Joined: Feb 2016
Posts: 8,667
Likes: 408
Needs to Get Out More!
Offline
Needs to Get Out More!
Joined: Feb 2016
Posts: 8,667
Likes: 408
Hi Ed,

Kingpins are nominally one inch (24.5mm) diameter. Front brake discs 280mm diameter, rear drums 220mm.

Note that UK type approval document for latest 5 link variant shows this regarding maintenance:

16. ACCESS TO VEHICLE REPAIR AND MAINTENANCE INFORMATION
Section not applicable to cars produced in 'Small Series'


I would expect therefore that generic wear limits would apply during testing especially regarding king pin/bush given the relatively unique sliding axle front suspension i.e. wear may not be detectable with suspension unloaded.

Check out this thread also PM sent.


Richard

2018 Roadster 3.7
1966 Land Rover S2a 88
2024 Royal Enfield Guerrilla 450
1945 Guzzi Airone
Joined: May 2016
Posts: 51
E
Just Getting Started
OP Offline
Just Getting Started
E
Joined: May 2016
Posts: 51
I believe what is needed is rotor, front brake pads, rear brake shoe thickness. Also the vertical and horizontal dimension of the play in the kingpins
Thanks

Joined: Feb 2016
Posts: 8,667
Likes: 408
Needs to Get Out More!
Offline
Needs to Get Out More!
Joined: Feb 2016
Posts: 8,667
Likes: 408
I think if your authorities are asking for vertical play limits with the kingpins they have not taken on board just how this relatively unique suspension system works.

Can your dealer not help with the other stuff?


Richard

2018 Roadster 3.7
1966 Land Rover S2a 88
2024 Royal Enfield Guerrilla 450
1945 Guzzi Airone
Joined: May 2016
Posts: 51
E
Just Getting Started
OP Offline
Just Getting Started
E
Joined: May 2016
Posts: 51
i have asked, waiting for answers. They tell me that have to contact Morgan Motors, due to time difference it was too late Friday

RichardV6 #556151 27/01/19 09:25 AM
Joined: Apr 2014
Posts: 6,957
Likes: 116
Talk Morgan Sage
Offline
Talk Morgan Sage
Joined: Apr 2014
Posts: 6,957
Likes: 116
Originally Posted By Richard Wood
I think if your authorities are asking for vertical play limits with the kingpins they have not taken on board just how this relatively unique suspension system works.

Unique or not unique..


Best Regards
Lang may yer lum reek
Joined: Nov 2015
Posts: 8,671
Likes: 489
Just barreling along
Needs to Get Out More!
Offline
Just barreling along
Needs to Get Out More!
Joined: Nov 2015
Posts: 8,671
Likes: 489
Originally Posted By BobtheTrain
Originally Posted By Richard Wood
I think if your authorities are asking for vertical play limits with the kingpins they have not taken on board just how this relatively unique suspension system works.

Unique or not unique..


It's Richards theory of relativity laugh2


Jon M
Joined: May 2016
Posts: 51
E
Just Getting Started
OP Offline
Just Getting Started
E
Joined: May 2016
Posts: 51
State is looking for "printed" data from the manufacture. I am striking out in trying to find something "official"
I really need some help on this. My temporary tags expire next week!

Page 1 of 3 1 2 3

Moderated by  TalkMorgan 

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.5