If you have a Plus 8 on the Aero chassis and fitted with the Morgan rack you will know that removing the rack leaves a pair of "prongs" sticking up.
This photos shows what i mean, and with the rear cover removed for an annual clean inside:
Another view with the cover on and from the side.
I felt this looked untidy and after some thought made up a single bar to bridge the gap.
I used 15mm copper water pipe, with a couple of soldered joints. Why copper tube? Simply because I had some bits in the garage and it is easy to work with.
Painted silver to match the roll bar here it is:
Looks OK, certainly much better than the two prongs.
it needs to be chrome and without joints!
I also wonder if it should curve up from the rear panel so it stands a bit higher.
And from the top:
I'll think about it for a while, listen to comments and then see if I can find "someone" to make it!
Let me know what you think!
