Originally Posted By springerbob
Good morning gentlemen. I need to replace an axle bearing. It is a BTR, non slip diff, fitted to an '04 4/4. Could anyone point me toward a 'how to guide' or supply relevant torque settings (if they exist). Also how much clearance do I need to remove the drive shaft. The garage is only eight and half feet wide and I don't want to find I have to knock a hole in the wall to get it out frown. I have looked on Gomog but cannot find the relevant info. Thanks.
. Unless I have missed something you will need at least half the width of the car from the wheel arch to remove the halfshaft.

.+8 Now gone for a 1800 4/4. Duratec in bright yellow.