Dave, Okay then, I'm warming to it. If anyone else has an opinion, do chip in please. Meabh.
I must confess, I've got the whole collection here.
I acquired one of the brass MWS tools ( for hex nuts) as a give away from a mate who was changing to eared spinners. Then, in a fit of economic madness, I got one of Uncle Phil Ledgerwood's tools. On the latter, I agree with Dave W. It is an excellent, quality bit of kit but it ain't cheap and you have to supply your own breaker bar. I used it a fair bit and it always worked fine.
I've recently changed over to eared spinners and so went for the MG Tool
Again, this seems fine- I've taken the wheels off/ replaced them a few times with it and it works really well
G
