Hello,
I have been upgrading my headlights to full led - blackout style to include the indicator (removing the standard pods which suffer with heat).
early 2012 car
Whilst making the connections I accidentally allowed a couple of wires to touch, whilst the ignition & indicator were on - my stupid mistake - again.
Everything worked correctly following a temporary wire up (just to check) prior to making more permanent connections & subsequent mistake
The push in 3 pin led flasher relay (red) blew - I have since sourced and fitted a replacement.
With the new relay fitted, the rhs indicators work fine, the hazards work fine, however when you signal left - all the indicators flash, the dash light signals hazards?
Following research on TM I decided that the Indicator module was probably the culprit - ordered and fitted a new one - no change
Thought a bit more - ordered & fitted a new column stalk - still no change/improvement.
Have been to MMC today - asked if they have a detailed wiring diagram I could buy - regret they don't.
Does anybody have any other ideas/suggestions??
Any help is appreciated
Thanks
Andrew
