Talk Morgan Forums Morgan Sports Cars Maintenance & Servicing Tool Tray mods

So I'm not sure to post this here or under 'What have you bodged today?'
Because this is a failed attempt at a tool tray
Start with the original

Time was spent measuring and using cardboard depth templates

Producing a tray ready for aluminium edges


Was pleased with it until when fitting found that the deep part is not deep enough for the Jack !
Seems I need an additional deeper step between the area over the fuel tank and the diff, that also does not foul the leaf spring (so probably the same width as the tank). But then only on the drivers side because of the brake pipe.

Oh well start planning version 2
Should mention it's a 2018 +4