Apologies to all if this has been asked before (my browser is corrupting searches on this site)

I have a 1996 plus 4 with a t16 engine and I need to replace the coolant pump. Is anyone able to advise the torque settings for the engine mount and angled bracket as I'll need to remove it to gain access to the pump?

That is:

1) Two bolts holding angled bracket to engine block (via aluminum housing) at top
2) Two bolts attaching rubber engine mount to underside of angled bracket
3) Two bolts attaching rubber engine mount to lower bracket


Also, any advice on torque settings for the screws that hold the coolant pump and cover in place?


Any help is much appreciated as I am struggling to find detailed settings anywhere.

Thanks,
Martin

1996 Morgan +4 (4-seater)
1975 Triumph Spitfire 1500