|
|
|
0 members (),
302
guests, and
92
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
Wales
by Joske Vermeule, September 1
|
|
|
|
|
|
|
|
|
|
|
Forums39
Topics49,872
Posts837,705
Members9,596
| |
Most Online1,063
Jun 14th, 2026
|
|
|
|
Joined: Feb 2013
Posts: 516 Likes: 58
Talk Morgan Regular
|
Talk Morgan Regular
Joined: Feb 2013
Posts: 516 Likes: 58 |
You could try cutting a couple of slots along the thread of an old plug (with a hacksaw) and running it in and out a few times to clean the thread in the head.
David Byrne
|
|
|
|
|
Joined: Nov 2015
Posts: 8,686 Likes: 493
Just barreling along Needs to Get Out More!
|
|
Just barreling along Needs to Get Out More!
Joined: Nov 2015
Posts: 8,686 Likes: 493 |
You could try cutting a couple of slots along the thread of an old plug (with a hacksaw) and running it in and out a few times to clean the thread in the head.
David Byrne Just what I was going to suggest, grease the 'cuts' and see what they pick up
Jon M
|
|
|
|
|
Joined: Oct 2016
Posts: 513 Likes: 2
Talk Morgan Regular
|
|
OP
Talk Morgan Regular
Joined: Oct 2016
Posts: 513 Likes: 2 |
Thanks for the brakes tip trodnik. I'll have a proper look when I disassemble.
|
|
|
|
|
Joined: Jul 2011
Posts: 1,245 Likes: 30
Has a lot to Say!
|
|
Has a lot to Say!
Joined: Jul 2011
Posts: 1,245 Likes: 30 |
Nick As per another thread on rear brakes. Make sure you have the tool for pressing the new circlip onto the new brake slave cylinder, or you will be working on it for hours. They are obtainable from the MG owners club as per Dave's post on the other thread.
4/4 Ivory 4.1:1 axle, Mercedes A200 AMG
|
|
|
|
|
Joined: Oct 2016
Posts: 513 Likes: 2
Talk Morgan Regular
|
|
OP
Talk Morgan Regular
Joined: Oct 2016
Posts: 513 Likes: 2 |
Yes - I have the cylinder and ordered the MGOC fitting tool last night. I figured exactly that - a dedicated tool is worth far more than i costs!
|
|
|
|
|
Joined: Nov 2016
Posts: 122
L - Learner Plates On
|
|
L - Learner Plates On
Joined: Nov 2016
Posts: 122 |
Hi Nickplus4. Given everything you have so far tried I would buy the thread restorer suggested by TBM. I've never seen one but it looks a brilliant tool and although quite expensive if it works it will be very cost effective. You can always sell it on, probably within the club, or offer to hire it out ???
Good luck, John.
|
|
|
|
|
|
|
