|
|
|
1 members (+8Rich),
231
guests, and
35
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
|
|
|
|
Wales
by Joske Vermeule, September 1
|
|
|
Forums39
Topics49,911
Posts838,152
Members9,635
| |
Most Online1,063
Jun 14th, 2026
|
|
|
|
Joined: Jul 2020
Posts: 59 Likes: 1
Just Getting Started
|
OP
Just Getting Started
Joined: Jul 2020
Posts: 59 Likes: 1 |
Hi all , bolted to the back of the seat there is what I can only describe as a guide for the belt and me being quite tall when I have the driver’s seat as far back as it will go the belt gets trapped .Is this bolt on guide needed because if it wasn’t I could recline the seat further back gaining much needed inches ? ( no jokes about inches needed unless they are funny )
|
|
|
|
|
Joined: Feb 2016
Posts: 8,702 Likes: 416
Needs to Get Out More!
|
|
Needs to Get Out More!
Joined: Feb 2016
Posts: 8,702 Likes: 416 |
I recall someone fitting a taller guide to an Aero chassied car I believe. Guessing this would solve your issue especially if the new guide had rollers less likely to jam.
Richard
2018 Roadster 3.7
1966 Land Rover S2a 88
2024 Royal Enfield Guerrilla 450
1945 Guzzi Airone
|
|
|
|
|
Joined: Dec 2017
Posts: 2,223 Likes: 183
Talk Morgan Expert
|
|
Talk Morgan Expert
Joined: Dec 2017
Posts: 2,223 Likes: 183 |
My 94 +8 has the belt guides attached to the seat which I assume are the same or similar to yours. The answer to your question is that the guides are not needed but you will find if removed the belt can slip off your shoulder, they are not difficult to remove so why not test and see.
Last edited by britmog; 21/02/21 10:46 PM.
Bruce
1964 4/4 Series V Comp (Megan)
1994 +8 (Maurice) tis no more
2013 M3W (Olga)
|
|
|
|
|
Joined: Jul 2011
Posts: 1,246 Likes: 30
Has a lot to Say!
|
|
Has a lot to Say!
Joined: Jul 2011
Posts: 1,246 Likes: 30 |
I fashioned up two substantial bars to reposition the guides. L/h to keep seat belt away from her in doors neck. R/h to allow the belt to run easier.
4/4 Ivory 4.1:1 axle, Mercedes A200 AMG
|
|
|
|
|
|
|
