Talk Morgan Forums Morgan Sports Cars Morgan Three Wheeler & Super 3 Crank Position Sensor - Let's find an alternative

The impedance of the sensor is 1030 ohms, I have just dissected a bad model S&S sensor to try to transform it xwedge, my backup sensor is an xwedge sensor which had the cable cut which I repaired by attaching a Deutch directly to it with gold plated connector and made an extension cable always with gold lugs and has been tested for a few hundred kilometers without problems






I am going to lengthen the new modified sensor with a tube that has a mounting bracket for the screw.

I got to my end by extending the sensor and spending the afternoon there, I could have reused the sensor cable because it was long enough.




I had thought of buying Bitcoins to get rich I didn't, I should have bought crankshaft sensors.

It is good to soften the sharp edge at the entrance of the sensor. I have already noticed when dismantling that the O-ring was damaged and that to put a new sensor back in, you have to focus considerably.

Black Adder I could lend you a sensor for a while, but your client must not put out forest fires in the south west of France with his three wheels.

[url=https://zupimages.net/viewer.php?id=22/33/qz68.jpg][img]

GLLOQ - I fixed the image link for you (talkmorgan can't handle image links with "https://", but it works if you change it to "http://")

I tested yesterday it works normally I even wiped out the storm with half-melted hail on the way back for 30 minutes.

Nice neat sensor!

I will order a KIA or HYUNDAI 391802B000 sensor, it has two wires of 1035 ohms, length 46 mm, the diameter will be a surprise.
https://fr.aliexpress.com/wholesale?catId=0&initiative_id=SB_20220817021109&origin=y&SearchText=KIA+%3A+391802B000&spm=a2g0o.detail.1000002.0

I think I would have to find an oscilloscope to compare the signal from the sensor.

Ideally you want length=36mm, not 46mm.