So, the task continues.............
The exhaust was in a bit of a state, but had to come off to access the running board underside.
Here it is after a general refurb. The replacement clamps came off the Roadster a while ago. Stainless does polish up with a bit of effort.
Tailpipe:
Note the rear valance is quite rough cut around the mounting.
All refreshed. Note my signature neoprene protector for the end of the running board.
No need to disturb the existing bolts. There is enough thread protruding to take a couple of nuts and washers.
Front mounting:
Front offside wheel:
And again after some elbow grease:
Tyre not treated at this stage.
Underside now reasonable!
More to follow..........
