Originally Posted By SimonH
Originally Posted By Button
Originally Posted By SimonH
You don’t want to have the track rods level to reduce bump steer
They should be as close as possible to perpendicular to the king pin

Simon @ SiFab.co.uk


I thought it was level with the ground. But as Simon states "Perpendicular to the king pin makes more sense. As My track rods are sloping slightly up with the rod end on top - maybe a problem. I drilled the cone out and use Rod Ends with a SAE thread bolt, sourced from Pegasus Racing, so they can be attached either on top or on the bottom of the stub axle. I will switch them back to the bottom and see if this solves My bump steer.


Slightly up is correct
Remember the kingpin is inclined at about 5-6 degrees

Simon @ SiFab.co.uk


Don't You mean "Slightly Down" to compensate for Caster which is about 2 degrees.

Or am I getting confused with Camber which is about 4 degrees on My +8.

Button