Thanks John.
I ran the wires under the fender to the center down tube fender support. I drilled a small hole in the top of the down tube, deburred the hole and ran the wire down inside it. I sealed the top of the tube/hole so the wire would not wiggle and chaff and also seal off the hole from water and dirt getting into it. Then I slid armor flex plastic sheathing, the same stuff Morgan uses, up the pipe from the exit. I made a generous bend at the bottom of the loop and took the cable up to the top of the A-Arm and across to the pivot and made the connection there since it was the least amount of movement for the wiring.
It all works fine but I intend on adding a quick disconnect, waterproof, for removal of the fender to change wheel/tires.
Photos coming soon.
