Ok, not strictly Morgan related but as I’m running out of things to do I’m sorting my toolboxes I think it would look cool to fit out my drawers with foam to hold all my sockets, spanners etc in place. My question is are there any techniques to cut the foam? Looking on YouTube it looks easy enough to cut out the shape with a sharp scalpel but is there a better way of removing the “waste”?
Funny!
I just startet to do the same.
I bought some l-boxx cases (Bosch/ Sortimo) for my cordless drills and angle driver and looked for some foam to use as inset.
I had to decide between "very nice to have" and practicability.
The best and perhaps cheapest way was to buy the foam insets from l-box. They are easy to get in shape and not more expensive than som foam sheets.
I have to store 3 Sets of tools at 3 locations so guess how I decided..
