Talk Morgan Forums Community The Malvern Arms 3D printing

Hi,

The taps are Dorf Manorhouse. I think Dorf taps have been bought by Caroma taps



I did buy some parts from a UK place paying a lot more for postage than the parts cost and Franke rings a bell. Unfortunately they were much too big. The parts I need have 19 teeth, the outside of the teeth is 1/2inch, the outside of the collar on the bottom is 9/16 and the overall height is 7/32. Inside is sort of square as they go on a shaft that has flat sides but I think if I get some plastic parts with the right number of teeth and external size I can file the inside out to match, even if too high I can cut them down, I think getting the right fit on the outside is the most important thing.



I have looked around lots of plumbing shops here with no luck, if you could have a look that would be great.

Thanks
Chris.