Originally Posted By MorganMatt
Very ambitious project. You should consider publishing a repair guide for this.

Any chance you could share the Timken part numbers?

Did you change the input shaft seal? Mine is leaking and would like to take care of it. Might be a good opportunity to quite the bearings as well.

Did you run the BB without the isolation kit to get a baseline on the noise reduction with just the new bearings?


All of the part numbers were on the bearings, I will have to look to see if I kept the boxes. I have the seal box and will get you that number because it is not on the seal itself. I would not do a repair guide on this because I have to put more miles on mine first to make sure everything continues to function the way it should. My rebuild was not prompted by noise alone, I picked up a vibration from the pinion on deceleration.


"Know the black and white before you walk in the gray"