I am close to starting the install on my Vibeater motor mounts. I have a couple of questions on some bits I received in the kit and before I trouble Craig with questions I thought I’d see if anyone on here can help.
My first question in on the aluminum parts I have circled in the following photo:
https://www.tm-img.com/image/iM3PKThey aren’t mentioned in any install notes. What are they?
Next question is about the bolt and rubber bushing in this existing photo from the notes posted earlier in this thread. See circled item in red:
https://www.tm-img.com/image/iMtEC I don’t see the same with my kit, however there are two smaller rubber bumpers in the first photo that I think may replace them and are a change from the original kit.
My entire kit is in this photo:
https://www.tm-img.com/image/iMkeg I have a good understanding of what I need to accomplish here, except I have one extra issue in that the sensor for the oil temp/pressure gauge will have to be reoriented. I have had quite a bit of experience ripping stuff apart and successfully putting it all back together better thanks to all the selfless help I received here on the forum. Chain drive upgrade and bevel box seals, etc. Many thanks!
Will
