One more thing. My M3W came from factory with what amount to nearly 6 degrees of toe out. Alignment didn't get checked During the PDI and it fragged the front tires in about 1,400 miles.
A quick and inexpensive way to check toe is to get a "straight" 2 by 4 (8 ft), cut it into two 4 foot sections, center each section on a front tire, clamp them firmly to the tire and then use a tape measure to measure across the front ends and rear ends. If the number you see is the same front and rear, you have zero toe, if not, adjust accordingly.
Last edited by rolsmith; 27/04/17 04:19 PM.
