Originally Posted by Rog
Snap Dave! Picked up a bargin on eBay, too. Mine's an unused mohair with no fasteners so need to fit those. I have the fasteners on the car though. Where did you get your fasteners?

From what Tim says I think I need to get those extra zips in first thumbs

Hi Rog,

The press studs came from here:

https://trimmingshop.co.uk/

I needed eight males (4 each side) with integral screws, but with press studs you tend to get males and females as a set, I went with stainless steel.

The Lift-dot 5/8" stainless steel screw studs I bought were genuine DOT, and came from here:

https://www.ebay.co.uk/itm/32322520...r=&widget_ver=artemis&media=COPY

There are three in the dash, but I only needed to buy two as oddly Monty had the central one fitted from new?

I pressed a 50p sized disc of Blutak against the panel, the pushed each tonneau press sud lightly into it to make an impression, this gave me a reliable centre for the drilling, I used a tiny 1.5mm drill bit which proved perfect for the pilot holes.