Sounds great. Got the cams off the cam plate tonight so moving along. Just checking on the lifters as one fell out as the magnet was not well positioned. is there a certain way the lifter goes back up or pretty much push it back up and make sure the roller is aligned left to right?
The other issue is the belt tension round thing is dented on the edge so I will need to order a new one. Not fun as that is a spendy little devil.
Mine too was dented on the edge! Same guy must have installed the belts :-( And you are correct over $210 for that little devil!!
Good thoughts 2Sharp and all else who contributed to this Thread.
I am doing roller rockers at the same time. A tip, get the correct stud remover tool and the correct stud installing tool...
