Talk Morgan Forums Morgan Sports Cars Maintenance & Servicing Fog Light Wiring

That's a helpful photo Rog, thanks

When I looked up from underneath all I could see was the PCB allowing zero access to the back of the gauge panel, I can now see it's mounted to the panel on two studs so perhaps the way to approach this is to undo the nuts and drop it out of the way?

Fitting the switch where the security LED currently resides a nice idea, but of course that would mean finding a new home for the LED.




I did see this Richard and agree it would be the ultimate setup, but it's a lot to change and a great deal of cost when all I am really trying to do here is fit one small illuminated toggle switch.


It's looking likely the answer could be to drop the PCB from its mounting studs to gain better access from beneath, and then fit the illuminated toggle switch here....





Using an amber illuminated toggle switch rather than blue, this one from Durite has a nicer bezel nut too (Durite Part Number: 0-603-10).





It's rated at 10a, but I asume it's only triggering a relay?

I've also gone for this tag.