Originally Posted by bobar
What a terrific job.

My 2012 plus4 PCB failure caused one light to remain illuminated. The only solution offered was complete replacement of the board at significant cost. The malfunction appeared to have been caused by water ingress.

My solution of sticking electrical tape over the light paused the irritation, but pales somewhat in seeing your elegant work.

Morgan should be beating a path to your door with a consultancy proposal.


thumbs
There’s an old TM image of a pcb that suffered from water damage or a short in the indicators. Can’t remember precisely but it burnt out some of the tracking which is shown here repaired. Quite an expensive fuse…
[Linked Image]



Originally Posted by bmgermany
Here a foto from the labels I made with a labelprinter - not the best solution but it works...

[Linked Image]

That’s a very nice dash indeed Bernt. Do you still have your pcb somewher behind there?

Roger
2011 Plus 4