Originally Posted by TBM
Originally Posted by PaulyG
Thanks! I'd like to say it was easy, but it was far from it. I think the order is the key. And getting the nuts on the U-bolts is good to do while there is still plenty of room. Finish tightening them when everything else is complete.

One question I have, I've read that I should torque the U-bolts nuts to 30 ft lbs. I only have a conventional torque wrench that I would normally put a socket on, but that won't fit between the chassis and the springs. Any suggestions?


I used a normal spanner, and did them up 'tight'. After a couple of weeks I checked them all over and gave them another tweak.


That's what I did.


Paul
Costock, UK
2014 4/4 Rolls Royce Garnet Red
Disco 5
Teddy - 17h1 Irish Draught cross